| PIC18C801 | ||||
|---|---|---|---|---|
| CONFIG1H (address:0x300001, mask:0x03, default:0x03) | ||||
| OSC -- Oscillator Selection bits (bitmask:0x03) | ||||
| OSC = LP | 0xFC | LP Oscillator. | ||
| OSC = EC | 0xFD | EC Oscillator. | ||
| OSC = HS | 0xFE | HS Oscillator. | ||
| OSC = RC | 0xFF | RC Oscillator. | ||
| CONFIG2L (address:0x300002, mask:0x41, default:0x41) | ||||
| PWRT -- Power-up Timer Enable bit (bitmask:0x01) | ||||
| PWRT = ON | 0xFE | PWRT enabled. | ||
| PWRT = OFF | 0xFF | PWRT disabled. | ||
| BW -- External Bus Data Width bit (bitmask:0x40) | ||||
| BW = 8 | 0xBF | 8-bit External Bus mode. | ||
| BW = 16 | 0xFF | 16-bit External Bus mode. | ||
| CONFIG2H (address:0x300003, mask:0x0F, default:0x0F) | ||||
| WDT -- Watchdog Timer Enable bit (bitmask:0x01) | ||||
| WDT = OFF | 0xFE | WDT disabled (control is placed on the SWDTEN bit). | ||
| WDT = ON | 0xFF | WDT enabled. | ||
| WDTPS -- Watchdog Timer Postscale Select bits (bitmask:0x0E) | ||||
| WDTPS = 1 | 0xF1 | 1:1. | ||
| WDTPS = 2 | 0xF3 | 1:2. | ||
| WDTPS = 4 | 0xF5 | 1:4. | ||
| WDTPS = 8 | 0xF7 | 1:8. | ||
| WDTPS = 16 | 0xF9 | 1:16. | ||
| WDTPS = 32 | 0xFB | 1:32. | ||
| WDTPS = 64 | 0xFD | 1:64. | ||
| WDTPS = 128 | 0xFF | 1:128. | ||
| CONFIG4L (address:0x300006, mask:0x01, default:0x01) | ||||
| STVR -- Stack Full/Underflow RESET Enable bit (bitmask:0x01) | ||||
| STVR = OFF | 0xFE | Stack Full/Underflow will not cause RESET. | ||
| STVR = ON | 0xFF | Stack Full/Underflow will cause RESET. | ||
This page generated automatically by the device-help.pl program (2017-05-13 09:29:49 UTC) from the 8bit_device.info file (rev: 1.36) of mpasmx and from the gputils source package (rev: svn 1308). The mpasmx is included in the MPLAB X.